
Plates emerging with grit on them, a shallow pond under the lower rack, or a program that gives up partway? Our technician stops by your Barrie kitchen, identifies the failed part and has the racks unloading spotless again.
Built-in, panel-ready and drawer dishwashers share a familiar list of breakdowns. Each card shows where our diagnosis begins.
Leftover rice wedged in the mesh, a jammed impeller or a stuck one-way flap keeps the water from leaving.
We check: filter assembly, drain pump, check valve
Clogged nozzles on the arms, a tiring wash pump or too little fill water leaves food stuck on plates.
We check: spray arms, circulation pump, inlet valve
Door rubber squashed out of shape, a cracked seal at the sump, or a loosened fitting below is usually behind it.
We check: door seal, sump gasket, supply connection
The heating element isn't warming the rinse, or the sensor that controls it gives wrong readings.
We check: heating element, thermistor, rinse aid dispenser
Worn latch contacts, a failing keypad or the overflow float tripping will cut a program short.
We check: door latch, keypad, overflow float
Glass or bone fragments in the pump chamber, or a pump motor with worn bearings.
We check: pump chamber, motor bearings, chopper blade
Dishwashers we work on
Korean, American and European names alike: our team works on the makes Barrie homeowners actually own, from basic builder units to premium built-ins, with service manuals and the right tools for each.
Book NowBrand not listed? Ask anyway, there's a good chance it's one we handle too.










Miele and Maytag dishwashers display codes like these when a program stops. Here's what each one means.
Water not draining
Make sure the pump cover is seated properly, then clean the filters and the drain pump.
Try this firstWater inlet problem
Confirm the supply tap is open, clean the inlet filter and straighten any kinks in the line.
Try this firstHeating relay fault
An internal fault the owner can't fix. A technician needs to replace the affected part.
Call a technicianLeak protection triggered
Close the supply tap, switch the dishwasher off, unplug it and arrange a repair.
Call a technicianExcess suds
Overdosed or unsuitable soap. Scoop out the foam, then run a couple of empty cycles.
Try this firstOverfill float tripped
An unlevel cabinet can lift the float. Level the dishwasher and cut power for thirty seconds.
Try this firstControl module problem
If the code comes back after a thirty-second power reset, the control needs servicing.
Call a technicianHeating system problem
The heating circuit isn't working as expected. Persistent codes need a technician.
Call a technicianYour code isn't among these, or it's back right after a reset? Phone us to set up a technician visit.
(249) 202-8722Barrie kitchens with clean dishes and dry floors again.
Dirty water kept collecting after each wash. He fished a shard of glass from the pump housing, inspected the seals and only left after a full trial wash. Works like new.
Our dishwasher left a small puddle under the door. A new door seal fixed it, and he mentioned a couple of loading tips that actually help.
Cloudy glasses, gritty plates, the works. Both arms were clogged with debris. Cleaned, tested and the results are great now.
Before booking a visit, take a minute to go through these simple checks.
Lock and power
Disable the child lock and confirm the breaker or switch under the sink is on.
Filter rinsed
Unscrew the cylinder filter below the lower rack and rinse it in the sink.
Spray arms spinning
Spin both arms by hand and poke out any clogged nozzles with a toothpick.
Hot water ready
Running hot water at the faucet first means the opening fill starts warm.
Best left to a pro
Dishes still not clean?
For anything past these steps, call certified and insured technicians.
Drop your details into the form and our Barrie office will phone you back to arrange a convenient arrival. No long hold music, no guessing when someone will show.
Rather talk to a person right now?
(249) 202-8722Request your visit
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.